Hpa Commands - Comtech EF Data KST-2000L Installation And Operation Manual

Satellite Terminal System
Terminal Mode Commands
Preset Command
Configuration Response
Clear
Status
Response
Lock Mode Command
Response
Status
Response
System Status
Configuration Response
Status
AGC Command
Response
Status
Response
7.4

HPA Commands

Commands and responses for controlling and determining the status of HPAs.
HPA Command
Power Enable Response
Status
Response
External Command
Fault Enable Response
Status
Response
<add/CPGM_n'cr' Where n = 1, 2 or 3
>add/CPGM_n'cr''lf']
<add/CPGM_'cr'
>add/CPGM_'cr'
1 – xxx'cr' Where xxx = Programmed or None
2 – xxx'cr'
3 – xxx'cr'lf']
<add/LM_xx'cr' Where xx = LK (lock) or DS (disable), default = DS
>add/LM_xx'cr''lf'] Lock mode prevents the present settings from being changed.
<add/LM_'cr'
>add/LM_xx''cr''lf']
<add/OS_'cr' Returns block of data on addressed unit.
>add/OS_'cr' nnnnn.n = frequency
UCF_nnnnn.n'cr' nnnnn.n = frequency
DCF_nnnnn.n'cr' xxx = ON, WRM, OFF
RF_xxx'cr' nn.n = attenuation
UCA_nn.n'cr' nn.n = attenuation
DCA_nn.n'cr' n = 1, 2, 3, or NONE
SEL_n'cr''lf']
<add/UAGC_xxx'cr' Where xxx = ON, OFF
>add/UAGC_xxx'cr''lf']
<add/UAGC_'cr'
>add/UAGC_xxx'cr''lf']
<add/HPE_xxx'cr'
>add/HPE_xxx'cr''lf']
<add/HPE_'cr'
>add/HPE_xxx'cr''lf']
<add/XFE_xxx'cr'
>add/XFE_xxx'cr''lf']
<add/XFE_'cr'
>add/XFE_xxx'cr''lf']
7–5
Where xxx = ON/OFF, default is OFF
(For ADAP SSPAs only)
Where xxx= ON/OFF, default is ON
Determines if the system takes action on HPA fault
notification
Revision 2
MN/KST2000L.IOM