Advertisement
Operating Instructions and Parts Manual
Operation
(Continued)
12-VOLT DC RECHARGING
This unit is NOT
CAUTION
!
intended for
recharging a car battery.
Never start the car
CAUTION
!
(vehicle) when the
12-volt DC recharging adapter is
plugged into the cigarette lighter.
NOTE: Charging the battery while the
car engine is not running drains the car
battery and is not recommended. If the
unit is used too long after the yellow
light comes on, recharging time could
take up to 7 hours.
To recharge the battery using the 12-
volt DC adapter while driving, follow
the subsequent procedures:
1. Insert the 12-volt DC recharging
adapter into the 12-volt DC output
socket.
2. Insert the other end into the
cigarette lighter and rotate to make
a good electrical contact.
3. The inflator should be charged for 5
to 6 hours while driving before the
initial use. After multiple uses, re-
charge the inflator for 3 hours.
BATTERY INDICATOR LIGHTS
Green and yellow lights show the
battery condition. The green light
indicates a charged battery. The yellow
light indicates the battery is low and
needs recharging. The red light
indicates the AC charger is connected
and charging.
If the battery is drained after the
green light is off, the life of the
battery may be shortened.
GREEN
YELLOW
LIGHT
LIGHT
ON
OFF
ON
ON
OFF
ON
OFF
OFF
INFLATION INSTRUCTIONS
WARNING
!
while the unit is running.
WARNING
!
locked to secure the inflation
accessories. Any misuse could cause
property damage or personal injury. Use
extreme caution when using inflation
accessories.
CAUTION
!
cool for 20 minutes after 20 minutes of
continuous operation. If not cooled
properly the inflator will overheat.
NOTICE
touches the core of tire valve stem.
After the battery is charged, the inflator
is ready for use. If the battery has not
been charged, see sections 120-VOLT AC
CHARGING or 12-VOLT DC CHARGING
before continuing.
1. Remove valve stem cap. Attach the
universal adapter from the air
inflator to the valve stem with the
lever in the up position. Be sure to
press universal adapter down over
valve stem threads completely.
When universal adapter is firmly in
place, press locking lever down to
lock onto valve stem (See Fig 1).
Universal
Adapter
Figure 1
RED
BATTERY
LIGHT
INDICATION
OFF
Full to Normal
OFF
Weak-Needs Recharging
OFF
Exhausted-Needs Recharging IMMEDIATELY
ON
AC charger connected
2. To use the inflation accessories,
Do not leave the
inflator unattended
The universal
adapter must be
3. Insert the appropriate inflation
4. Turn on the power and the
5. When the object is firm, turn the
Turn unit off to
allow inflator to
12-VOLT DC POWER SUPPLY
Make sure the
The inflator can supply power to 12-
universal adapter
volt DC items rated under 15 amps by
simply inserting the item's plug into
the 12-volt DC output socket. Do not
attempt to connect items exceeding
the 15 amp, 12-volt rating.
FUSE REPLACEMENT
When replacing the fuse, make sure
the inflator is turned off and nothing is
connected to the inflator. A spare 15
amp fuse is supplied with the inflator
(See "Specifications and Features"
sheet for location of fuse) . NEVER
replace a blown fuse with a fuse having
a higher rating.
Storage
Store the inflator between 65°F (18°C)
and 75°F (24°C) with the universal
adapter in the open position. Make
sure the power switch is in the off
Lock
position.
Battery Disposal
This product contains a rechargeable
sealed lead-acid battery. The
environmental laws in some states
require retailers to accept returns of
Valve Stem
rechargeable batteries for proper
disposal. Check the state environmental
laws before disposing this product.
Technical Service
For information regarding the
operation or repair of this product,
please call 1-800-543-6400.
2
insert piece into the universal
adapter and push the lever to lock
into place (See Figure 1). The
inflation accessory will fit securely.
accessory into the inflatable object.
compressor switch.
inflator off. Do not over inflate
objects.
Advertisement
