Force Bump When Overdue; Force Calibration When Overdue - BW Technologies MicroClip XT Technical Reference Manual

GasAlertMicroClip XT
Technical Reference Guide
with the IR Link. This option is available only if configuring the
GasAlertMicroClip with the base station. Default interval is 15 seconds.

Force Bump When Overdue

When enabled, if a sensor(s) is past due for a bump test, the sensor(s)
must be bump tested immediately, otherwise the detector deactivates.
A bump test should be performed regularly to ensure the sensors are
responding correctly to gas. The following screen displays when the
option is enabled and the sensor(s) is overdue.
To enable Force Bump When Overdue, complete the following:
1. Click the Force Bump When Overdue checkbox to
enable.
2. Enter a value (1-365 days) in the
If 0 is entered in the Bump Interval field, the Force Bump
When Overdue option is automatically disabled.
The detector is shipped with Force Bump When Overdue disabled.
For information and procedures, refer to
28
Bump Interval field.
a Caution
Bump Test.

Force Calibration When Overdue

When enabled, if a sensor(s) is past due, the sensor(s) must be cali-
brated immediately, otherwise the detector deactivates.
Enable Force Calibration When Overdue to ensure calibrations are
performed regularly and sensors are operating correctly. The following
screen displays during the startup sequence when the option is enabled
and the sensor(s) is overdue.
To enable Force Calibration When Overdue, complete the following:
1. Click the Force Calibration When Overdue checkbox to
enable.
2. Enter a value (1-365 days) in the
(Cal Interval) field.
If 0 (zero) is entered in the Cal Interval field, the Force
Calibration When Overdue option is automatically disabled.
The detector is shipped with Force Calibration When Overdue dis-
abled.
For more information, refer to Calibration.
Calibration Interval
a Caution