Brush Cleaning; Cleaning Of Tank And Vacuum Grid With Float - Clarke Vantage 17 cable Operator's Manual

BRUSH CLEANING

CAUTION:
It is advisable to use protective gloves when
cleaning the brush because there may be cutting
debris.
1. Remove the brush from the machine, according to the
procedure shown in the Use chapter.
2. Clean and wash the brush with water and detergent.
3. Check the brush bristles for integrity and wear; if
necessary, replace the brush.
CLEANING OF THE TANK AND VACUUM GRID
FLOAT
1. Make sure that the power supply cable (A, Fig. 18) is
disconnected from the electrical mains. Roll up the power
supply cable on the handlebar into position (D).
2. Drive the machine to the appointed disposal area.
3. Lift the cover (A, Fig. 19) and apply the cover stand (B),
then clean and wash the cover, the tanks (C and D) and
the vacuum grid (E) with clean water.
Drain the water from the tanks by means of the drain
hose (B, Fig. 18) and valve (C).
4. If necessary, release the retainers (F, Fig. 19), open the
vacuum grid (E), remove the float (G), then carefully
clean and reinstall them.
5. Check the cover sealing gasket (H, Fig. 19) of the
recovery tank for wear.
NOTE:
The gasket (H, Fig. 19) creates vacuum in the tank,
which is necessary for the vacuuming of the
recovery water.
If necessary, replace the gasket (H, Fig. 19) after
removing it from the housing (I).
When reassembling the new gasket, install the joint (J) in
the central area, as shown in Fig. 19.
6. Check the gasket (H, Fig. 19) seating surface (K) for
integrity and sealing capabilities.
7. Check the vent hole (L, Fig. 19). If clogged, clean it.
NOTE:
The hole (L, Fig. 19) compensates the air in the cover
interspaces, thus allowing the creation of vacuum in
the recovery tank.
8. Remove the cover stand (B, Fig. 19) and close the cover
(A).
Operator's Manual - Vantage 17 Cable
C
Figure 18
H
I
A
H
B
J
K
L
Figure 19
EN
ENGLISH
B
D
A
F
E
G
F
C
D
19