Table of Contents
Advertisement
1.
Always ask and check the following:
A. Is the unit connected to a live power source?
B. Check the circuit breaker.
C. Is power switch on?
D. Is the unit operating on proper voltage?
2.
If problems exist after checking the above, check the chart below.
3.
If any service is needed
shouldbeperformedbyanAPWWyottauthorizedserviceagency.
PROBLEM
Won’t toast...
a. Toaster cold.
b. Wrong power switch position.
c. Wrong conveyor speed setting.
Toasts unevenly... d. Only part of product surface is
e. Product located to far to side of
Product sticks to
f. Butter or butter substitute used
conveyor or slide..
g. Conveyor surface has baked-on
h. Very moist or doughy product.
i. Product not defrosted or thawed. i. Defrost/thaw product.
No power...
j. No power to receptacle.
k. Toaster unplugged.
l.
m. Power switch.
Won’t heat...
n. Loose connections.
o. Faulty power switch.
p.
Lighter toast under
q. Speed control setting.
peak loads...
r. Very moist product.
s. Product too cold.
t. Toaster cavity temperature being
Conveyor won’t
u. No power.
Move...
v. Conveyor links are binding.
w. Loose or bad connection between
x. Conveyor motor burnt out.
y.
7. TROUBLESHOOTING
s), call anAPW Wyott authorized service agency.All service
(italicized item
CAUSE
toasted.
Conveyor.
on product.
oil
residue.
Loose connections.
Burnt out element.
quenched.
speed control and conveyor motor.
Speed control burnt out.
SOLUTION
a. Allow five (5) minutes for warm up.
b. Position power switch to full power.
c. Reduce conveyor speed.
d. Reduce conveyor speed.
e. Place product on conveyor between
End links.
f. Discontinue use of butter or butter
substitute.
g. Follow daily cleaning methods to
remove & prevent residue.
h. Use different source or day old product.
j. Check circuit breaker.
k. Plug in toaster.
l.
Check connections.
m. Check that switch is on & operational.
n. Check connections.
o. Replace power switch.
p.
Replace element.
q. Reduce speed control setting.
r. Use different source or day old
product.
s. Allow product to warm to room
temperature.
t. Add 1” or more spacing between
product.
u. Check circuit breaker.
v. Check conveyor for bent links.
w
. Check for loose or bad connection.
x
. Replace conveyor motor.
.
Y
Replace speed control.
7
Advertisement
Table of Contents
