Changing The Incoming Ring Tone; Adjusting The Incoming Ring Tone Volume - AU W65T Basic Manual

• Even in manner mode, the cell phone still emits a
sound when autofocusing, a shutter sound when you
take a photo.

Changing the Incoming Ring Tone

When the standby screen is displayed, press [.
Use G to select Function and then press
[ (Select).
Use G to select Sound/Vib/Lamp and then
press [ (Select).
Use G to select Incoming Setup and then press
[ (Select).
Use G to select Incoming Call and then press
[ (Select).
Use G to select
[ (Select).
Use G to select Original and then press
[ (Select).
Use G to select Ringtone (Pattern 3) and then
press [ (Set).
The incoming ring tone is set.
If you press K (Play), the tone plays.
•
Press J (OK).
20
(Ringtone) and then press
Adjusting the Incoming Ring
Tone Volume
When the standby screen is displayed, press [.
Use G to select Function and then press
[ (Select).
Use G to select Sound/Vib/Lamp and then
press [ (Select).
Use G to select Incoming Setup and then press
[ (Select).
Use G to select Incoming Call and then press
[ (Select).
Use G to select
then press [ (Select).
Use G to adjust the volume and then press
[ (Set).
Each press of G changes the volume one step.
•
The ring tone volume gradually increases.
STEP
The ring tone volume gradually decreases.
STEP
Maximum
Standard The ring tone sounds at the set volume.
Minimum
The ring tone does not sound.
OFF
Press J (OK).
(Ringtone Volume) and