Daytime Running Lights; Windshield Wiper De-Icer; Windshield Wipers - Subaru Tribeca 2011 Quick Reference Manual

Windshield Wipers

To turn wipers on, press the wiper
control lever down one level for
intermittent, two levels for low, or three
levels for high speed. Return the lever
to the "OFF" position to stop wipers.
For a single wipe/mist, pull the lever
toward you. To spray washer fluid
spray, press the washer button at the
end of the wiper control lever.
To operate the rear wiper, turn the
knob on the end of the control lever
forward to intermittent, continuous,
or wash position. Turn the end of the
lever backward for wash operation
when the rear wiper is not in use.
When the automatic transmission is
placed in reverse, the rear wiper will
operate continuously even when the
rear wiper is in the "INT" position.
OFF
1
HIGH

Daytime Running Lights

Daytime running lights are standard
on your vehicle. A reduced brightness
high beam will be automatically turned
on by the daytime running light system
when the engine has started and the
parking brake is fully released or the
light switch is in the "OFF" or "
position. You must always switch on
your headlights when it's dark outside
by turning the light switch to the
" " position.

Windshield Wiper De-Icer

Remove the snow from
your windshield before
starting this system.
To begin de-icing,
push the button (the light will illuminate
while in operation). The de-icing
system automatically shuts off after
about 15 minutes. If more time is
required, push the button to reactivate
the de-icer.
INT.
LOW
"
11