Table of Contents
Advertisement
SCSI Device Configuration
Press <Enter> and the following sub-menu screen appear. The sub-menu screen allows
you to specify the configuration for each device on the SCSI bus.
Sync Transfer Rate (MB/Sec)
The field allows you to specify the maximum synchronous data transfer rate
depending on the type of each SCSI device. Select [ASYN] to enable asynchronous
negotiation for some older SCSI devices.
Packetized
When enabled, the device drivers support this option.
However, this option is not supported by the BIOS.
QAS
When enabled, the device drivers support this option.
However, this option is not supported by the BIOS.
Initiate Wide Negotiation
When set to [Yes], the field allows wide SCSI hard drives to use 16-bit (2 bytes)
transfers.
Enable Disconnection
This field tells the SCSI controller whether or not to allow the specified SCSI device
to disconnect during an I/O transfer operation. The disconnection ability frees the
SCSI bus to allow other I/O processes and thus optimizes the SCSI bus performance.
Setting options: [Yes], [No].
77
Advertisement
Table of Contents
