Table of Contents
Advertisement
5.2.2 Configure/View SCSI Controller Settings
There are 8 items in the "Configure/View SCSI Controller Settings" screen. These items display or
allow you to change the SCSI controller's settings. Use the arrow keys to highlight the item and then
press <Enter> to select the value you want in each item or enter each item's sub-menu screen.
5.2.2.1 SCSI Bus Interface Definitions
SCSI Controller ID
The item is used to assign a SCSI ID to the SCSI controller. It is recommended that
you should leave the default setting unchanged.
Settings: [0]~[15].
SCSI Controller Parity
Use the field to enable or disable SCSI parity error checking function. If any of your
SCSI devices does not support parity checking, disable this function. While disabling
the function, you should disable disconnections for all devices, as parity checking for
the reselection phase is NOT disabled. A non-parity device's I/O operation will never
complete if the reselection fails due to a parity error.
SCSI Controller Termination
In order to have the SCSI bus function properly and reliably, termination at the ends of
the SCSI bus is necessary. Proper termination can ensure signal on the SCSI bus will
not reflect and cause data loss or errors.
Settings options: [Enabled], [Disabled].
75
Advertisement
Table of Contents
