Installer System Test - Honeywell T7300F Installation Instructions Manual

4. Press Run Program.
Run
Program
Set Program Set Temperature
Run Occupied Unoccupied Occupied
Program Start Time Start Time Day Temp
Temporary Set Current Clear
Occupied Day/Time Start Time Copy
Continous
Unoccupied System

INSTALLER SYSTEM TEST

Use the Installer System Test to check the thermostat
configurations and operation. Refer to Table 3 for a list of
the available system tests.
Table 3. Installer System Tests.
Test
Number System Test Description
10 to 19 Heating equipment can be turned on and
off.
20 to 29 Emergency heat (Q7300C,D,H [heat
pump models only]) equipment can be
turned on and off.
30 to 39 Cooling equipment can be turned on and
off.
40 to 49 Fan equipment can be turned on and off.
60 0 to Keyboard keys test.
60 19
70 to 79 Thermostat information including date
code, software versions and subbase
identification are displayed.
To start the system test:
CAUTION
Possible Equipment Damage.
Equipment damage can result if compressor is
cycled too quickly.
The minimum off time for compressors is
bypassed during the Installer System Test.
Key to
Press
Heating Equipment System Test
Heat/Cool Settings
∆
∆
∆
∇
∇
∇
T7300F SERIES 2000 COMMERCIAL MICROELECTRONIC CONVENTIONAL
AM
Change
Time/Temp
Unoccupied
Temp
Mon
Heat/Cool Occupied 1
Settings
System Fan
Fan
Heat
Table 4. Installer System Test Options.
Test
Number
10 Enter heating equipment system test.
11 Stage-one heat turns on. The system fan is also energized.
12 Stage-two heat turns on. Stage-one heat and system fan remain on.
13 Stage-three heat turns on. Stage-one and stage-two heat with the system fan
are on.
12 Stage-three heat turns off.
11 Stage-two heat turns off.
10 Stage-one heat and system fan turn off.
Press and hold the increase
the same time, until 10 appears. All segments of the LCD
are displayed for three seconds before 10 appears. See
Room
Fig. 5 and 6.
Auto
M4954A
Set Program
Em Ht Em Ht
Aux Ht Aux Ht
Comm
Mon TueWedThuFriSatSun
Un Occupied 12 Override
System
Em Heat
NOTE: If a duct temperature sensor is installed, the duct
temperature is also displayed.
Refer to Table 4 and Thermostat Information section for
directions and results of the specific system tests.
NOTE: Press Run Program to exit the system test. The
system test times out after four minutes without
any key presses.
7
OR HEAT PUMP THERMOSTAT
and
Start Time Set Day/Time Set Day/Time
AM
PM
In Recovery
Lo Med
Off Cool Auto Wait
Fig. 5. LCD Display of all segments.
TEST NUMBER
Fig. 6. Test number display.
Description
decrease keys, at
Temporary Setting Enrg
Sav
Room
%Humid
Heat Cool Remote
Auto Only Duct
Hi Fan
On Auto
M4916
M10257A
62-0125—3