Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Best Power Patriot Pro II 400 VA
Summary of Contents for Best Power Patriot Pro II 400 VA
- Page 1 USER GUIDE ® Patriot Pro II 400VA, 750VA and 1000VA...
- Page 2 English ....1...
-
Page 3: User Guide
® Patriot Pro II 400VA, 750VA and 1000VA User Guide LTM-1325A © Copyright 1999, Best Power. All rights reserved. -
Page 4: If You Have A Question
A service technician is available 24 hours a day, 365 days a year. Just call Worldwide Service or the nearest Best Power office, or send a fax to the Worldwide Service Fax number. Please have your unit’s serial number available when you call;... -
Page 5: Table Of Contents
Best Power Offices ........ -
Page 6: Safety Instructions
The installation and use of this product must comply with all national, federal, state, municipal or local codes that apply. For assistance, call Best Power’s Worldwide Service or your local Best Power office. -
Page 7: Ups Features
UPS Features The Best Power Patriot Pro II provides protection against power problems, including power outages, brownouts and sudden increases in power. It also provides spike suppression and line noise filtering to protect your equipment. Front panel LEDs and an audible alarm keep you aware of the unit’s status. -
Page 8: Quick Startup
Patriot Pro II. Please fill out the warranty registration card and return it to your local Best Power office. If you are in the U.S.A. or Canada and you would like to activate the Warranty for Transient Voltage Surge Suppression, please return the registration card within 10 days of installation. -
Page 9: Symbols, Leds And Audible Beeps
Symbols, LEDs and Audible Beeps The front panel LEDs and an audible beep indicate the unit status. The unit beeps whenever the unit is on battery power or an alarm is present. See Table 2 for information on beep coding. In the figure below, bucking means that Patriot Pro II is reducing high input voltage, and boosting means Patriot Pro II is increasing low input voltage. - Page 10 To silence an alarm, press the button on the front panel. The beep will stop, but ALARM SILENCE the alarm light will stay on. Note: Silencing the alarm does not solve the problem that caused it. See Tables 2 and 3. If your Patriot Pro II runs on batteries frequently because the input utility line varies often, you may want to adjust your Patriot Pro II to accept wider voltage variations before switching to batteries.
-
Page 11: Troubleshooting
(located on the rear of the unit) available. If the unit must be returned, Best Power will give you a Return Materials Authorization (RMA) number. Phone Best Power for an RMA number before returning the unit for any reason. -
Page 12: Replacing The Batteries
Replacing the Batteries Patriot Pro II’s batteries are user-replaceable and can be replaced while the Patriot Pro II has AC input applied and powers the loads. This means that, if necessary, you can replace the batteries while the UPS is running. Before you replace the batteries, make sure that you read the safety information below. -
Page 13: Replacement Instructions - 400Va Models
Replacement Instructions - 400VA Models Phone Best Power’s Worldwide Service to order a replacement battery pack. It must be the same type and rating as the original battery. See Battery information in Specifications. If it is necessary, the battery may be replaced while the Patriot Pro II is running with the protected equipment attached. -
Page 14: Replacement Instructions - 750Va And 1000Va Models
Replacement Instructions - 750VA and 1000VA Models Phone Best Power’s Wordwide Service to order a replacement battery pack. It must be the same type and rating as the original batteries. See Battery infromation in Specifications. If it is necessary, the batteries may be replaced while the Patriot Pro II is running with the protected equipment attached. -
Page 15: Communication Port
Communication Port The Patriot Pro II is plug-and-play compatible with Windows 95. The Patriot Pro II comes equipped with CheckUPS II power management software. An interface cable for the following systems is provided. SCO UNIX/XENIX UNIX and Compatible Systems OS/2 Windows 3.X, 95 and NT Novell NetWare DB-9 Pinouts... -
Page 16: Specifications
Specifications Best Power reserves the right to change specifications without prior notice. Line Transient Protection: Passes ANSI/IEEE C62.41 Category A testing. Safety Compliance: Model U: Tested to UL1778; tested to electrical standards of UL1449, and CAN/CSA C22.2 No. 107.1 M95. -
Page 17: Warranty
PURCHASER must promptly notify BEST POWER in writing within the duration of the warranty or not later than one month after expiration of the warranty. BEST POWER’s obligation under this warranty is... -
Page 18: Limited Warranty
You are advised to consult applicable state laws. No warranty is made with respect to other products sold by BEST POWER which do not bear the name BEST POWER, and no recommendation of such other product shall imply or constitute any warranty with respect to them. - Page 19 BEST POWER. This warranty is operable only upon the written acceptance by BEST POWER of an application by the PURCHASER on BEST POWER’s standard form for the above warranty coverage for the Product sold. In...
-
Page 20: Best Power Offices
Toll-free: 1-800-356-5794 (U.S.A. and Canada) Winchester FAX: 1-608-565-2221 Hampshire International FAX: 1-608-565-7675 SO23 7RX ENGLAND Best Power Technology Mexico, S.A. de C.V. Telephone: (44) 1962 844414 Golfo de Riga, 34 Toll-Free: 0800 378444 Colonia Tacuba FAX: (44) 1962-841846 México D.F. 11410 MÉXICO... -
Page 21: Appendix A: Adjusting Voltage Settings
10 seconds, the values will change to the default values, and any previous changes you have made will be lost. If you have a question, contact the nearest Best Power office, or call Worldwide Service at 1-800-356-5737 or 1-608- 565-2100. - Page 22 3. Use the appropriate table on the next page to decide Press this button which combination of settings you need; note which BRIEFLY to LEDs must be lit for this combination. Then briefly scroll through the (about 1 second) press the button shown to move to the settings.
- Page 23 Table 4: Voltage Settings for U Models (400U, 750U, and 1000U) To Inverter Nominal To Inverter LEDs Lit Boost Buck (Input AC is Low) Voltage (Input AC is High) 2, 3, 4 (Default) 1, 3, 4 2, 3, 5 1, 3, 5 3, 4, 5 2, 4, 5 3, 4, 6...
- Page 24 For Users in the United States only: For all “U” Models Note: This equipment has been tested and found to comply with the limits for a Class B device pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when this equipment is operated in a commercial environment.
Need help?
Do you have a question about the Patriot Pro II 400 VA and is the answer not in the manual?
Questions and answers