Related Manuals for Electrolux 2.7 Cu.FT
Summary of Contents for Electrolux 2.7 Cu.FT
-
Page 1: Service Manual
@G@8USPGVYÃCPH@ÃQSP9V8UTÃIPS UCÃ6H@SD86 SERVICE MANUAL TOP LOAD WASHERS 2.7 & 3.0 Cu. Ft. Tubs :KLWH:HVWLQJKRXVH 5995377099 November 2002... -
Page 2: Safe Servicing Practices - All Appliances
Electrolux Home Products cannot be responsible, nor assume any liability, for injury or damage of any kind arising from the use of this manual. -
Page 3: Section B - Owners Guide
SAFE SERVICING PRACTICES QUICK REFERENCE SHEET SAMPLE WIRING DIAGRAM SAMPLE TIMER CHART SECTION A - OPERATING INSTRUCTIONS SECTION B - OWNERS GUIDE... - Page 4 SECTION C - INSTALLATION INSTRUCTIONS SECTION D - PARTS LOCATION AND THEIR FUNCTION SECTION E - ELECTRICAL OPERATION...
-
Page 5: Section F - Troubleshooting Flow Charts
SECTION F - TROUBLESHOOTING FLOW CHARTS SECTION G - TEARDOWN... -
Page 7: Quick Reference Sheet
QUICK REFERENCE SHEET... - Page 9 Connecting drive motor for bench check Two Speed Three Speed...
-
Page 12: Section A - Operating Instructions
SECTION A - OPERATING INSTRUCTIONS SOAK & REGULAR / 15 12 WASH/RINSE TEMPERATURE WASH CYCLE OPTIONS LOAD SIZE WASH / SPIN SPEEDS PREWASH WHITES PREWASH WARM GENTLE RINSE GENTLE M E D I U M WARM NORMAL GENTLE E X T R A R I N S E POWER SCRUB POWER SPIN POWER... - Page 15 SECTION B - OWNERS GUIDE...
- Page 19 Removable Fabric Softener Dispenser (some models)
- Page 20 TREATMENT STAIN...
- Page 21 STAIN TREATMENT...
- Page 27 FRIGIDAIRE GALLERY TOP LOAD WASHER WARRANTY (UNITED STATES) Your Frigidaire product is protected by this warranty FRIGIDAIRE, THROUGH ITS AUTHORIZED THE CONSUMER WILL BE WARRANTY SERVICERS, WILL: RESPONSIBLE FOR: PERIOD Pay all costs for repairing or replacing any parts of this Costs of service calls that are listed under FULL ONE-YEAR One year from original...
- Page 28 Service Information (Canada)
-
Page 29: Warranty (Canada)
WARRANTY (CANADA) GALLERY AUTOMATIC WASHERS AND DRYERS FRIGIDAIRE HOME PRODUCTS PARTS AND SERVICE... -
Page 30: Section C - Installation Instructions
SECTION C - INSTALLATION INSTRUCTIONS... - Page 31 3. In an area (garage or garage-type building) where gasoline of other flammables are kept or stored (including automobiles). ↑ 96" Max. ↑ (244 cm) 33" Min. (83.82 cm) ↓ ↓ LID OPEN 90° 51" WATER (129.54 INLETS (REAR) 44" 11-7/16"...
- Page 32 CABLE TIE CABLE TIE...
- Page 34 SECTION D - PARTS LOCATION AND THEIR FUNCTION SPEED SWITCH CIRCUIT AGIT/SPIN EG/S EG=EXTRA GENTLE N=NORMAL F=FAST G=GENTLE S=SLOW...
- Page 36 TEMPERATURE SWITCH CIRCUIT WASH/RINSE FF-H FF-C R C/C R W/C R W/W H=HOT R=REGULATED OPTION SWITCH C=COLD W=WARM OPTION POWER SCRUB/ EXTRA RINSE EXTRA RINSE POWER SCRUB X=SWITCH CLOSED...
-
Page 43: Section E - Electrical Operation
SECTION E - ELECTRICAL OPERATION... - Page 44 ° ° °...
- Page 51 SECTION F - TROUBLESHOOTING FLOW CHARTS NOTE: Always check the wiring and pin/plug connectors before replacing any component.
- Page 52 Washer completely inoperative. Note: Always check wiring to the components. Timer does not advance. Note: Always check wiring to the components.
- Page 53 Washer does not drain. Note: Always check wiring to the components. Drive motor operates in spin but not in agitation. Note: Always check wiring to the components.
- Page 54 Drive motor does not turn. Note: Always check wiring to the components.
- Page 55 Drive motor operates in agitation but not in spin. Note: Always check wiring to the components. Slow water fill. Note: Always check wiring to the components.
- Page 56 Drive motor cycles off and on rapidly when the speed switch is set to Normal. Note: Always check wiring to the components. Drive motor cycles off and on rapidly when speed switch is set to Gentle. Note: Always check wiring to the components.
- Page 57 Drive motor cycles off and on rapidly when speed switch is set to ExGentle. Note: Always check wiring to the components. Auto Temp Control does not control the wash water temperature within specifications. Note: Always check wiring to the components.
- Page 58 Water fill does not turn off. Note: Always check wiring to the components. Incorrect water level. Note: Always check wiring to the components.
- Page 59 Washer will not fill in any setting of the temp switch. Note: Always check wiring to the components.
- Page 60 Washer will not fill in wash cycle, but will fill in rinse with the temp switch set to Cold/Cold. Note: Always check wiring to the components. Washer will only fill with cold water in the wash cycle, with the temp switch set to Warm/Cold. Note: Always check wiring to the components.
- Page 61 Water temperature is too hot or too cold in the wash cycle with the temp switch set to Warm/Warm. Note: Always check wiring to the components. Washer will only fill with hot water in the wash cycle, with the temp switch set to Warm/Cold, but does fill with cold in the rinse cycle.
- Page 62 SECTION G - TEARDOWN...