Table of Contents
Advertisement
Basic operation (Continued)
Mark (Red)
Connector
CAMERA
SR-W7MAU (W-VHS)
(Optional)
UNDER
PULSE
COLOR
MUTING
DEGAUSS
SCAN
CROSS
OFF
SLOT 1
SLOT 2
SLOT 3
A
B
C
D
E
MENU
SCREENS
ASPECT
AREA
INPUT SELECT
VOLUME
CHECK
MARKER
DT-V1900CG
(Optional)
Isolation transformer AA-V31U
(Optional)
18
Connector Cap
Camera head
OUTPUT LEVEL
WHITE BALANCE
MENU SETTING
AUTO
MANUAL
AUTO
MANUAL
ON
OFF
CAMERA
SETTING
ON
ADJUST
RED
BLUE
GAIN
SHUTTER
ENHANCE
FREEZE
BAR
OFF
CCU
Camera control unit
DZ-VCA3U
POWER
F
AC 120V
Operation of Micro HD camera
Check system operation according to the following
procedures.
1. Insert the camera connector while aligning it to the red
mark as shown on the left figure.
When cap is connected to the camera connector:
Turn the cap counterclockwise to remove it.
2. Connect the endoscope adapter to the C mount of camera
head.
3. When operating this system, set the switches on the CCU
panel as follows:
POWER
1) OUTPUT LEVEL
I
O
2) WHITE BALANCE : [AUTO]
3) MENU SETTING
4. Switch on DZ-VCA3U power.
5. Adjust the white balance.
System operation
Check system operation according to the following
procedures.
1. Insert the camera connector while aligning it to the red
mark as shown on the left figure.
When cap is connected to the camera connector:
Turn the cap counterclockwise to remove it.
2. When the camera is used as a system, connect the power
plugs of the camera and other equipments to the isolation
transformer AA-V31U.
3. Switch on isolation transformer AA-V31U power switch.
4. Switch on DZ-VCA3U power.
5. Switch on W-VHS power.
Insert W-VHS tape, and make sure that it can record.
6. Switch on the power of monitor.
Check that picture taken by camera can be displayed on
the monitor.
7. Operate each device according to its operating procedure.
Note : Consult JVC service personnel or authorized dealer
when connecting the system for the first time.
Do not disconnect, or modify the connection by
yourself.
: [AUTO]
: [OFF]
Advertisement
Table of Contents
