Service The Parksense® Rear Park Assist System; Cleaning The Parksense® System - Dodge 2014 JOURNEY Owner's Manual

Service The ParkSense® Rear Park Assist
System
During vehicle start up, when the ParkSense® Rear Park
Assist system has detected a fault condition, the Elec-
tronic Vehicle Information Center (EVIC) will actuate a
single chime, once per ignition cycle, and it will display
the "CLEAN PARK ASSIST", "SERVICE PARK ASSIST",
or "SERVICE PARK ASSIST SYSTEM" message. Refer to
"Electronic Vehicle Information Center (EVIC)" in "Un-
derstanding Your Instrument Panel" for further informa-
tion. When the shift lever is moved to REVERSE and the
system has detected a fault condition, the EVIC will
display the CLEAN PARK ASSIST , SERVICE PARK
ASSIST , OR SERVICE PARK ASSIST SYSTEM mes-
sages for as long as the vehicle is in REVERSE. Under this
condition, ParkSense® will not operate.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 249
If "CLEAN PARK ASSIST" appears in the Electronic
Vehicle Information Center (EVIC) make sure the outer
surface and the underside of the rear fascia/bumper is
clean and clear of snow, ice, mud, dirt or other obstruc-
tion and then cycle the ignition. If the message continues
to appear see an authorized dealer.
If "SERVICE PARK ASSIST" or "SERVICE PARK ASSIST
SYSTEM" appears in the EVIC, see an authorized dealer.
Cleaning The ParkSense® System
Clean the ParkSense® sensors with water, car wash soap
and a soft cloth. Do not use rough or hard cloths. Do not
scratch or poke the sensors. Otherwise, you could dam-
age the sensors.
3