Table of Contents
Advertisement
7. Installation of the Controls
7.1 D
IMENSIONS AND
H
C
UMIDITY
ONTROL
VT2W
AND
V
:
12 volts DC
OLTAGE
D
:
5" x 5" x 1³/
IMENSIONS
(127 mm x 127 mm x 35 mm)
5" (127 mm)
VC0016A
FRONT VIEW
7.2 I
NSTALLATION OF THE
Always disconnect the unit before making any connections. Failure in disconnecting power could result in
electrical shock or damage of the control or electronic module inside the unit.
Failure to comply with the following can cause erratic operation of the unit:
• Never install more than one optional control per unit.
• Keep control low voltage wiring at least 1 foot (305 mm) away from motors, lighting ballast, light dimming
circuit and power distribution panel. Do not route control wiring alongside house power wiring.
• Ensure the wires are securely connected.
7.2.1 Platinum Main Control Installation
1. Route the cable from the unit to a convenient location for the
control.
2. Detach the front module from the
mounting plate by pulling the
bottom part.
3. Run the cable (4 wires) through the
central opening of the mounting
plate and mount this plate to the
wall using screws (not included). If
needed, use wall anchors (not
included).
S
(M
PECIFICATIONS
AIN
, DH100W, B
, VT1W,
ASIC
"
8
1³/
(35 mm)
SIDE VIEW
M
C
AIN
ONTROL
VC0102
VC0103
C
)
ONTROLS
V
OLTAGE
D
IMENSIONS
"
8
VC0105A
!
WARNING
CAUTION
4. Splice back the end of the cable to
access the 4 wires. Strip the end of
each wire. Connect each wire to its
corresponding terminal on the back
of the front module: YELLOW wire
to "Y", RED wire to "R", GREEN
wire to "G" and BLACK wire to "B".
Be careful not to pinch wires when reinstalling the
front module on its back plate
5. Reinstall the front module over the back plate.
17
P
LATINUM
:
12 volts DC
:
4¼" x 4" x 1"
(107 mm x 102 mm x 26 mm)
4¼" (107 mm)
FRONT VIEW
CAUTION
.
1"
(26 mm)
SIDE VIEW
YELLOW
WIRE
RED
WIRE
GREEN
WIRE
BLACK
WIRE
VE0173
Hide quick links:
Advertisement
Table of Contents
