Maintenance; Scheduled Maintenance Table; Integrity Check Of Power Supply Cable And Extension - Clarke Vantage 17 cable Operator's Manual

MAINTENANCE

WARNING!
All maintenance operations must be performed by qualified personnel, or by an authorized Service Center.
WARNING!
Maintenance operations must be carried out:
– With the machine switched off
– With the power supply cable disconnected from the electrical mains
Moreover, read carefully the instructions in the Operator Safety Instructions chapter before performing any
maintenance operation.
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
Provided below is the Scheduled Maintenance Table. The intervals shown may vary according to particular working conditions, which
are to be defined by the person in charge of the maintenance.
This Manual contains the Scheduled Maintenance Table and describes only the easiest and most common maintenance
procedures.

SCHEDULED MAINTENANCE TABLE

Procedure
Integrity Check of Power Supply Cable and
Extension
Squeegee Cleaning
Brush Cleaning
Cleaning of Tank and Vacuum Grid with Float
Squeegee Blade Check and Replacement
Solution Filter Cleaning
Screw and Nut Tightening Check
Vacuum Motor Carbon
Replacement
(1): and after the first 8 working hours
(2): for these maintenance operations, contact an authorized Clarke Service Center

INTEGRITY CHECK OF POWER SUPPLY CABLE AND EXTENSION

Carefully check if the power supply cable, the extension and the plugs are worn or damaged.
If necessary, have them replaced by the Service Center.
Operator's Manual - Vantage 17 Cable
Daily or after using
the machine
Brush Check or
Weekly Every six months
(1)
ENGLISH
Yearly
(2)
17