Various Configurations *
General
The "Various Config" function (77) is used to select the following
default settings:
•
Routing of printouts to PRINTER or DTE port.
•
Routing of Service Announcements from LES/NCS.
•
Setting of response on the remote Message Indicator.
•
Selection between manual update of geographic position, and
automatic update through the NMEA-0183 port.
•
Enabling/disabling of low power standby detection level in the 2W telephone ports.
Setting
1
Select VARIOUS
CONFIG function (77):
2
Check current settings:
The example shows as follows:
•
printouts routed to PRINTER.
•
service announcements routed to PC.
•
Message Indicator responds to telefax
and telex.
•
manual course input, NMEA-183 off.
3
Select routing of printouts:
0=no output, 2=to printer,
3=to DTE port
4
Select routing of
Services Announcements, e.g. to PC:
0=no output, 1=to PC port.
2=to printer, 3=to DTE port.
5
Set Message Indicator response:
F=telefax, T=telex, D=data
(1=indication,
(SW version no. 2.03 and above only)
6
Select position input source:
0=manual input, 1=NMEA-0183 input
Note! When manual update has been selected,
new geographic position must be entered manually.
7
Turn on or off standby:
0=disabled (OFF), 1=enabled (ON)
and revert to IDLE:
3.22
=no indication)
*
Saturn Bm – Chapter 3. Configuration
7
7
FUNC
STU
STU
ENTER
MORE/
HELP
2
PLAY
ENTER
DEF
1
ENTER
ABC
1
1
DATA
ENTER
ABC
ABC
ØÅ.
1
ENTER
ABC
1
ENTER
ENTER
ABC
3x
ESC
ON
ON
ON
ON
ON
ON
ON
ON