Incoming Call Route - Nera Saturn BM Marine Operator's Manual

Incoming Call Route *

General
The Incoming Call route function no. 71 is used to link a received call
to the wanted end terminal connector(s). As a default, the HANDSET,
TEL.1, and TEL.2 connectors have been set up with a standard pair
of OI/DIs, see previous page. (E.g., an incoming call with an IMN
containing DI no.17 is routed directly through to connector TEL.2).
Setting Call Route
The connectors TEL.3 through TEL.5 have no default settings and
must be provided with the appropriate DI. Note that if changing a call
route, you may be prompted to delete the current setting first.
Example:
1
Select INCOMING
CALL ROUTE function (71):
2
ENTER list of DIs:
3
Key in new DI, e.g. 3 :
4
Key in service type:
1=telephone (TPH), 2=telefax (FAX)
4=telex (TLX), 5=high speed data (HSD)
5
Set the routing to
e.g. TEL.3 only:
H
1, 2, 3, 4, 5 : Telephone/telefax connectors
P
Setting=1 : IMN with DI is routed to device
Setting=
*
Note! A call can only be routed to a connector with the same service type as
that of the call. For other services such as telex or data communication and
high speed data transfer, see separate manuals for these settings.
Note down all settings in the list provided in
6
Check entries:
and revert to IDLE:
3.16
: Handset connector
: Not used in Saturn B
: IMN with DI is not routed to device
7 1
FUNC
STU ABC
ENTER
3
ENTER
GHI
1
ENTER
ABC
ENTER
1
DATA DATA DATA
ENTER
ABC
ØÅ. ØÅ. ØÅ.
appendix F.
ENTER
3x
ESC
Saturn Bm – Chapter 3. Configuration
ON
ON
ON
ON
ON
ON