PSC QuickScan QS6500 Reference Manual page 86

Data Editing
2. Scan the START bar code.
3. Next, scan the SET DATA GROUP 1 CHARACTER bar code.
4. Reference
assigned to each desired character. The corresponding hex number
for the '+' character is 2B; for the '#' sign, the hex equivalent is 23.
To enter the selection code, scan first the '2' and 'B' bar codes from
Appendix B, Alpha-Numeric Pad
5. Scan the SET bar code to accept the digits scanned.
6. Scan the END bar code to exit Programming Mode.
7. Data Group Characters are configured individually for each sym-
bology type, enabling or disabling the Data Groups you've created
using the options provided in the
The resulting message string after completing the steps above would
appear as follows:
Scanned bar code data:
Resulting message string output:
Data Group Characters — continued
START
MODE
Sets position and up to 22 ASCII characters each or
any hex value from 0 to 64. To configure this feature,
reference the section,
and Characters for Data Group 1
mation.
DEFAULT SETTING FOR THIS FEATURE: 00 (None)
Set Group 1
Position
Set Group 1
Character(s)
Set Group 2
Position
5-12
Appendix A, ASCII Conversion Chart
, then the '2' and '3' bar codes.
Symbologies
12345
12+#345
BARCODE
Example: Setting Position
for more infor-
®
QuickScan QS6500/QS6500 BT
, to find the hex value
chapter.