PSC QuickScan QS6500 Reference Manual page 78

Data Editing
Prefix/Suffix — continued
START
MODE
Sets up to 22 characters each from the set of ASCII
characters or any hex value from 0 to FF. To config-
ure this feature, scan the "START" bar code above to
place the unit in Programming Mode, then the "Set
Prefix" or "Set Suffix," followed by the digits from the
Alphanumeric table in
Pad
ence the section,
more information. Accept your selection by scanning
the "SET" bar code below and finally, exit program-
ming mode by scanning the "END" barcode below.
DEFAULT SETTING FOR THIS FEATURE: 00 (None)
Set Prefix
Set Suffix
SET
END
5-4
BARCODE
Appendix B, Alpha-Numeric
representing your desired character(s). Refer-
Example: Setting a Prefix
QuickScan
, for
®
QS6500/QS6500 BT