Table of Contents
Advertisement
Keyboard Wedge/USB Keyboard — cont.
Intercharacter Delay
NOTE
START
MODE
This delay is inserted after each data character trans-
mitted. If the transmission speed is too high, the sys-
tem may not be able to receive all characters. You may
need to adjust the delay to make the system work prop-
erly. Selectable from 00 to 255 in 10msec increments.
Use hexidecimal (range: 00 to FF hexidecimal) to set
the delay.
To configure this feature, scan the "START" bar code
above to place the unit in Programming Mode, then the
"Set Intercharacter Delay," followed by the digits from
the Alphanumeric table in
Numeric Pad
Accept your selection by scanning the "SET" bar code
below and finally, exit programming mode by scanning
the "END" barcode below
Set
Intercharacter
Delay
SET
END
Product Reference Guide
This feature does not apply to the USB Keyboard
interface.
BARCODE
representing your desired length.
DEFAULT SETTING FOR THIS FEATURE:
00 (No Delay)
Interface Features
Appendix B, Alpha-
4-33
Hide quick links:
Advertisement
Table of Contents
