Switching The Confirmation Beep On/Off (Beep); Muting During Telephone Mode; Telephone Audio/Navigation Audio - Blaupunkt Brisbane SD48 Operating And Installation Instructions

When you have finished making your
changes,
.... press the
MENU
button@.
To exit the menu,
.... press the ESC button@.
Switching the confirmation beep
on/off (BEEP)
The system will output a confirmation beep
for some functions if you keep a button
pressed down for longer than two seconds,
for instance, when assigning a radio station
to a station preset button. You can switch
the beep on or off.
.... Press the
MENU
button @.
The display shows IIMENU II .
.... Press the v or
A
button
0
repeatedly
untililBEEP ON II or "BEEP OFF" appears
on the display.
.... Press the> button
0
to call up the
submenu.
.... Switch the beep on or off using the but-
ton>
0.
1I0FF II means beep off, 1I0N II
means beep on.
When you have finished making your
changes,
.... press the
MENU
button @.
To exit the menu,
.... press the ESC button @.
Adjusting the volume
Muting during telephone mode
If your car sound system is connected with
a cell phone or navigation system, the car
sound system is muted when acall is incom-
ing or during a voice output of the naviga-
tion. The call or the voice output is played
back via the loudspeakers of the card sound
system. In orderfor this feature to work, the
mobile telephone or navigation system must
be connected to the car sound system as
described in the installation instructions.
You can find out from your Blaupunkt dealer
which navigation systems can be used with
your car sound system.
If a call is incoming or a navigation an-
nouncement takes place, the display shows
'TELEPHONE II .
Telephone Audio/
Navigation Audio
You can set the volume level at which the
telephone calls or navigation announce-
ments are mixed in .
.... Press the MENU button@.
The display shows IIMENU".
.... Press the
v
or
1\
button
0
repeatedly
untilllTEl VOlll appears on the display.
.... Press the> button
0
to call up the
submenu.
"TElVOl ll and the currently set value are
displayed .
.... Set the desired volume with the
v
or
1\
button
0.
I
13