Table of Contents
Advertisement
Chapter 7
Thomson Gateway Wireless Configuration
To return to auto mode:
1
In the Channel Selection list, click auto.
2
Click Apply to immediately apply your changes.
Network name broadcast
By default the AP broadcasts its SSID and accepts every station. However, for security reasons you are able to
configure the AP so that it does not broadcast its SSID and accepts only those stations who have exactly the
same SSID, as configured on the Thomson Gateway.
To change the Network Name broadcasting configuration:
1
Select Only stations with correct Network Name (SSID) can connect to disable Network Name
broadcasting.
2
Click Apply to immediately apply your changes.
When you enable this option, the SSID will not be broadcast. The Thomson Gateway wireless network will no
longer be visible in the list of available networks of your wireless station.
Enable/disable the wireless interface
To disable your wireless interface:
1
Clear Wireless interface enabled.
2
Click Apply to immediately apply your changes.
i
All your wireless stations will be disconnected!
You can also disable your wireless interface by pressing the front panel button for 10 seconds.
When the WLAN led is extinguished, the interface is disabled.
To enable the wireless interface:
1
Select Wireless interface enabled.
2
Click Apply to immediately apply your changes.
i
You can also enable your wireless interface by pressing the front panel button for 10 seconds
until the WLAN led starts flashing.
E-DOC-CTC-20060609-0001 v2.0
71
Hide quick links:
Advertisement
Table of Contents
