Navico 2kW Installation Manual page 61

For information about radar processor wiring and connections, Wiring guidelines (see "Wiring
the radar system" page 18).
A 2 kW AA010024
4 kW AA010025
B 2 kW AA010089
4 kW AA010091
C 2 kW AA010012
4 kW AA010013
D RIM 300 (003-7905-00) Radar Interface Module (RIM300) This cable will replace existing
power cable. Consists of a Connector which branches to three separate cables, with four
terminations. D1,D2,D3 and D4.Replacement part no. 000-0121-010.
2 kW scanner comes with a 15 m (49 ft) cable attached. (B)
4 kW scanner comes with a 15 m (49ft) cable that will need to be
connected to the scanner. Cable from Scanner connects to Radar
Processor box. An optional longer cable is available but only up to 20 m
(65.5 ft). For scanner part numbers (see "Navico radar part numbers"
page 75)
Optional 20 m (65.5 ft) scanner cable . Will require disassembly of
scanner to connect. Cable has a radar processor connector on one end,
and three small terminated flat connectors on the other.
CAUTION: This cable should only be installed by an experienced radar
service technician!
Radar processor box. No cables supplied. Connects to Lowrance
displays via RS422 protocol, using optional RIM300 cable kit (D).
Optional radar accessories kit (000-0127-45)
The 2 kW system is 12 V DC ONLY 25 W max. Power connects to the
two screw terminals.
4 kW system is 12 or 24 V DC
Connect to Lowrance Displays | 59