Navico 2kW Installation Manual page 33

Used to connect the radar processor directly to a NavComputer. Cable has female connectors on both ends
and joins two of the above standard ethernet cables together (see "Simrad GB40 using SimNet heading
sensor" page 32)
AA010084
24006694
Optional parts to connect (GB40 and 8000i) utility cable
AA010070
Ethernet crossover cable
Optional parts to connect (GB40 only)
AT10-HD
This is used to supply the radar
processor with heading information at
10 Hz from a SimNet heading source.
This is needed for MARPA and
accurate chart overlay. This connects
to the 12 pin NMEA / COMMS
connector on the radar processor.
This is used to supply the radar
processor with NMEA 0183 heading
information at 10 Hz from an NMEA
0183 heading source. This connects to
the 12 pin NMEA / COMMS connector
on the radar processor.
Connect Simrad GB40 or Northstar 8000i | 31