Advertisement
DataStorm D3
| Advanced Functions
DataStorm D3 Calibrations: Tilt
| DataStorm D3 Calibrations: Tilt |
ONLY USE THIS CALIBRATION IF YOU HAVE A LEGACY STYLE UPPER CONTROL BOARD
WHICH IS ATTACHED BETWEEN THE DISH ARMS; THESE HAVE NOT BEEN SHIPPED
IN NEW DATASTORM MOUNTS SINCE SEPTEMBER 2004 [F1 ONLY]
|
1-Starting the Tilt Calibration
Because this upper control board version
rests between the arms, it needs an initial
calibration to memorize it's level point.
User Guide
THE DISH MUST BE STOWED
|
3-Tilt Calibration Finish
You have completed the tilt
calibration. Please note the elevation
tilt on the main system status page for
tilt readings.
|
2-First Compass Reading
With the dish stowed, raise the DataStorm
until its arm is level [parallel with
the base plate]. When level, click next to
take the reading. [Typical level position is
up 3° from the stowed position.]
v.1
16
Advertisement
