Advertisement
DataStorm D3
| Standard Functions
DataStorm D3 Configuration Pages Cont.
| DataStorm D3 Configuration Page: Main 2 |
| 14-
Signal Quality Threshold
Sets the minimum signal quality needed to
peak on a satellite.
| 15-
Signal Strength Threshold
Sets the minimum signal strength needed to
peak on a satellite. Set Signal Strength Threshold
to a value as low as possible that does not
constantly start and stop azimuth movement. To set
this value, run a test dish and take note of the
lowest signal strength reading seen and set your
threshold for 30 points above that reading.
This value is 440 - 480 Typical.
|
16-Isolation Optimization
Has 3 settings:
-Partial [default]
Indicates that the D3 will perform a cross-pol
-Full
Indicates that the D3 will not only perform a
cross-pol but ensure it's optimization.
-None [test purposes only]
Indicates the D3 will not perform a cross-pol
and just connect.
User Guide
14
15
16
17
18
19
20
21
22
23
24
25
26
|
Update Settings
To have the D3 accept any
changes you must click the
'Update Settings' button to
store the new configuration.
|
17-Azimuth Search Window
Width in degrees of the actual search
pattern window the DataStorm will search
in for the satellite. [left and right on a
horizontal plane]
|
18-Elevation Search Window
Height in degrees of the actual search
pattern window the DataStorm will search
in for the satellite. [up and down on a
horizontal plane]
|
19-Motion Stow
If signal quality is lost for 30 seconds or more,
the dish will automatically stow if enabled.
|
20-Manual Location [GPS]
If enabled the manual GPS coordinates can be
placed here overriding the automatic
functioning of the DataStorm GPS module.
|
22-Azimuth Origin
The start mark in degrees for azimuth rotation.
v.1
11
Advertisement
