Advertisement
DataStorm D3
| Standard Functions
DataStorm D3 Configuration Pages Cont.
| DataStorm D3 Configuration Page: Main 1 |
10
11
12
13
|
1-Local Address
The IP address of the D3.
[Default is: 192.168.0.250]
|
2-Subnet Mask
The subnet mask of the D3.
|
3-Modem Gateway
The IP address of the Modem.
|
4-Router Gateway
LAN IP address of the router. If the D3 is
placed behind a router in the network.
|
5-DNS Address
The IP address of the modem.
|
6-Satellite System
Choose which satellite platform you are using;
i.e. Generic , DiRECWAY, iDirect, etc.
|
7-Satellite Longitude
This value indicates the satellite you are
searching for in degrees.
User Guide
1
2
3
4
5
6
7
8
9
|
Update Settings
To have the D3 accept any
changes you must click the
'Update Settings' button to
store the new configuration.
|
8-Frequency
The assigned transponder frequency on your
assigned satellite.
|
9-RX Polarization
Based on your assigned transponder it can be
vertical or horizontal.
|
10-TX Polarization
Based on your assigned transponder it can be
vertical or horizontal.
|
11-Symbol Rate
Usually can be left at default but refer to your
satellite platforms documentation.
|
12-LO Frequency
Spec from the mount's LNB; default is 10750 and
should be changed by calling tech support.
|
13-Signal Amplifier
Default is enabled. Should only be changed by
calling tech support.
v.1
10
Advertisement
