Table of Contents
Advertisement
Setup
Network configuration
Static IP address
•
From your radio menu, select the 'Settings > Network config > Edit Config'
menu and then press SELECT.
•
The radio will now display 'Auto (DHCP)? YES / NO'. Turn the radio's rotary
encoder to select 'NO' and then press SELECT.
•
You will now be able to enter the IP address you wish to give your radio by
using the rotary encoder to select the desired numbers followed by pressing
SELECT
•
The radio will now prompt you to enter the required network mask for the
network. You will be able to enter this in the same way as before for entering
the IP address.
•
You will now need to enter the default gateway's IP address used by the radio
on the network.
•
Finally, you will need to enter the DNS IP address for the radio. On some
networks, you may need to enter your ISP's DNS IP address, which should be
available on your ISP's support page on their website.
•
After entering the above information, the radio will now connect successfully
to
your network. In order to make the radio use DHCP again (to automatically get
ts network information when it attempts to connect to a network), you will need to
select 'Configure > Network config > Edit Config' and then set 'Auto (DHCP)?
YES/NO' to 'YES'
Configuring the radio to use a wired Ethernet connection only
From the radio's 'Network config' menu, select 'Wired/Wireless'. This menu will
present you with three options: 'Wireless Only', 'Wired' and 'Auto'. Selecting 'Wired
Only' will allow cause the radio to reboot and then only use its Ethernet connection
to communicate with the network.
Configuring the radio to use a wireless Ethernet connection only
Selecting the 'Wireless Only' option from the 'Wired/Wireless' menu will allow
cause the radio to reboot and then only use its Wi-Fi connection to communicate
with the network.
to end inputting the address.
Advertisement
Table of Contents
