Table of Contents
Advertisement
Configuring the radio to use either an ethernet or a wireless connection
(AUTO mode)
Selecting the 'Auto' option from the 'Wired/Wireless' menu will allow cause
the radio to reboot and then attempt to establish an Ethernet connection, if it is
available, to communicate with the network. Otherwise, the radio will attempt to
establish a Wi-Fi connection to the network.
Once the radio has established a certain type of connection to the network, then this
type of connection will remain in use while the radio is on.
The 'Network Config' menu also allows you to choose whether or not the Internet
radio displays a warning message when its network signal strength is low. You can
enable this feature by selecting 'Signal Warning' and then selecting 'Yes'.
Firmware version cheeking
From your radio menu, select the 'Settings > Version>...
Display, will displays the versions numbers of the various parts of software and
hardware on your Internet radio.
Firmware upgrade
From your radio menu, select the 'Settings > Upgrade Firmware>...
Use this option to download new firmware for the radio from the Reciva portal on
the Internet. If there is new firmware available, then the radio will prompt you if you
want to download it or not. Note, at this stage, you can press the radio's BACK
button to cancel the radio beginning a firmware upgrade. A Firmware upgrade may
take several minutes, so do no switch off the power to the radio until the operation is
complete otherwise the radio may become permanently damaged
Language setting
From your radio menu, select the 'Settings > Language>...
This ,menu allows to you change the display language.
Advertisement
Table of Contents
