Voltage And Bios Setting - ICP Electronics LCD-Kit03 User Manual

4

Voltage and BIOS Setting

After all jumpers and connectors have been set and connected
correctly, the next step is to set the Voltage and BIOS of the LCD-
Kit03. These settings are done on your SBC.
Voltage Setting
The Supply Voltage for LCD-Kit03 is +5V. You must set the LCD
Voltage Setting Jumper on your SBC to +5V. Please, refer to SBC
User Manual of your SBC or refer to the following tables.
BIOS Setting
For SBCs with C&T 65555 LCD/CRT Interface Chipset, the setting
can be done simply in CMOS Setup. For SBCs with HM86508
LCD/CRT Interface Chipset, the BIOS setting must be done by
upgrading the VGA BIOS using the BIOS file in the attached disk.
Please, refer to the following tables for more detail information.
Note: To do the above settings, you must have one VGA monitor
connected to your SBC because your LCD-Kit03 may not work
correctly or even does not show anything before the Voltage and
BIOS settings are correct.
LCD-Kit03 640 x 480 / 18 bits
LTM10C209A
12