Power Management Setup - ECS NM70-TI User Manual

Power Management Setup


This page sets up some parameters for system power management operation.
Main Advanced
Power Management Setup
Resume By RING
Resume By PME
Resume By USB 1.x/2.0(S3)
EUP Function
Power LED Type
Resume By RING (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the Modem. You
must use an ATX power supply in order to use this feature.
Resume By PME (Disabled)
This item specify whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or components is
detected.
Resume By USB 1.x/2.0(S3) (Disabled)
This item allows you to enable/disable the USB device wakeup function from S3
mode.
EUP Function (Enabled)
This item allows user to enable or disable EUP support.
Power LED Type (Single Color LED)
This item shows the type of the power LED.
Press <Esc> to return to the Advanced Menu page.
34
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Chipset Tweak Boot
[Disabled]
[Disabled]
[Disabled]
[Enabled]
[Single Color LED]
Version 2. 15.1229. Copyright (C) 2012 American Megatrends, Inc.
NM70-TI USER MANUAL
Security Exit
About Resume by Ring

:Select Screen

:Select Item
Enter : Select
+/- : Change Opt.
F1:General Help
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit