2005 Mustang Workshop Manual
Is any voltage present?
B11 CHECK THE FUEL PUMP MODULE CIRCUITRY FOR AN OPEN
Ignition OFF.
Measure the resistance between the SJB C2280c-31, circuit 1357 (LB/YE), harness side; and
between the SJB C2280c-44, circuit 1356 (LG/VT), harness side.
Is the resistance less than 5 ohms?
B12 CHECK CIRCUIT 1356 (LG/VT) FOR AN OPEN
Measure the resistance between the SJB C2280c-44, circuit 1356 (LG/VT), harness side and the fuel
pump module C433-4, circuit 1356 (LG/VT), harness side.
Is the resistance less than 5 ohms?
B13 CHECK THE FUEL LEVEL SENSOR FOR AN OPEN
Ignition OFF.
Disconnect: Fuel Level Sensor C434 (RH Side).
Connect a fused jumper wire between the fuel level sensor C434-4, circuit 29 (YE/WH), harness side
and the fuel level sensor C434-2, circuit 1357 (LB/YE), harness side.
Ignition ON.
Wait one minute.
Enter the following diagnostic mode on the scan tool: Instrument Cluster Self-Test.
NOTE: Make sure to use only the instrument cluster DTCs for this step. Once the repairs are
complete, clear the SJB and instrument cluster DTCs.
NOTE: It is normal for DTC B2627 to be present during this step and should be ignored.
Clear the instrument cluster DTCs. Repeat the instrument cluster self-test.
Is DTC B2628 set?
B14 CHECK CIRCUIT 29 (YE/WH) FOR A SHORT TO VOLTAGE
Ignition OFF.
Disconnect: SJB C2280c.
Ignition ON.
Measure the voltage between the SJB C2280c-43, circuit 29 (YE/WH), harness side and ground.
Is any voltage present?
B15 CHECK CIRCUIT 29 (YE/WH) FOR A SHORT TO VOLTAGE WITH THE CIRCUIT ISOLATED
Measure the voltage between the SJB C2280c-43, circuit 29 (YE/WH), harness side and ground.
http://www.fordtechservice.dealerconnection.com/pubs/content/...
DTCs. REPEAT the self-test.
No
REPAIR circuit 1357 (LB/YE) for a short to voltage. CLEAR the
DTCs. REPEAT the self-test.
Yes
REMOVE the jumper wire. GO to B22.
No
REMOVE the jumper wire. GO to B12.
Yes
REPAIR circuit 1357 (LB/YE) for an open. CLEAR the DTCs.
REPEAT the self-test.
No
REPAIR circuit 1356 (LG/VT) for an open. CLEAR the DTCs.
REPEAT the self-test.
Yes
INSTALL a new fuel level sensor. REFER to
Section
CLEAR the DTCs. REPEAT the self-test.
No
LEAVE the jumper wire connected. GO to B14.
Yes
REMOVE the jumper wire. GO to B15.
No
LEAVE the jumper wire connected. GO to B16.
Yes
REPAIR circuit 29 (YE/WH) for a short to voltage. CLEAR the
DTCs. REPEAT the self-test.
Page 16 of 40
310-01.
11/14/2009