Sw&Pdl Function Assignments: Exp 1; Making Assignments On The Sw&Pdl Function Screen - Boss GT-10 Workshop Manual

Function What it Does
Lev +20 Increases the Patch Level parameter by a value
of 20.
Lev -10 Decreases the Patch Level parameter by a value
of 10.
Lev -20 Decreases the Patch Level parameter by a value
of 20.
Num Inc Switches the next-highest patch number.
Num Dec Switches the next-lowest patch number.
Bank Inc Switches the next-highest patch bank.
Bank Dec Switches the next-lowest patch bank.
LED Moment The switch's LED is turned on when the switch
is pressed, and turned off when the switch is
released. (Available for CTL 1 and CTL 2 only.)
LED Toggle The switch's LED is turned on when the switch is
pressed, and stays on until the switch is pressed
again. (Available for CTL 1 and CTL 2 only.)
The "LED Moment" and "LED Toggle" assignments don't control any
effects; they only control how the status LEDs on CTL 1 and CTL
2 behave. This can be useful when making more detailed control
assignments on the ASSIGN 1-8 screens, as described in a bit.
SW&PDL FUNCTION Assignments: EXP 1
Function What it Does
Off No assignment.
Foot Volume Assigns EXP 1 to PEDAL FX: Foot Volume.
Pedal Bend Assigns EXP 1 to PEDAL FX: Pedal Bend.
WAH Assigns EXP 1 to PEDAL FX: WAH.
PB/FV Assigns EXP 1 to toggle between PEDAL FX: Pitch
Bend and PEDAL FX: Foot Volume.
WAH/FV Assigns EXP 1 to toggle between PEDAL FX: WAH
and PEDAL FX: Foot Volume.
If you're setting EXP1 to the dual-function assignments PB/WAH or
WAH/FV, make sure you set one of the switches to "Pedal FX" so you
can toggle between the two settings. (Setting EXP PEDAL SW for this
purpose usually makes the most sense.)
Making Assignments on the SW&PDL FUNCTION Screen
From the Play screen, press MASTER/PEDAL FX.
1
Turn the dial to select PDL FX, and then press ENTER.
2
If necessary, use the 3 and 4 buttons to navigate to the SW&PDL
3
FUNCTION screen (Page 1 in the display). If the screen is not displayed
in list view as shown below, press DISPLAY MODE so it is.
Use the PARAMETER 1-4 knobs under the display to set the desired
4
function for CTL1, CTL2, EXPSw, and EXP1. (If you don't want to assign
a function to a particular foot switch or pedal, select "Off. " )
If you see a warning message that says
"XXX PREFERENCE is SYSTEM!" when
performing Step 4 above, it means that
the particular controller you're trying to
adjust is currently set to system-wide
operation. To set the preference back
to Patch, press EXIT, and then follow the
procedure described in "Setting Realtime
Controllers to the Same Settings for All
Patches" on Page 17 in this booklet.
When you're done, press EXIT twice to return to the Play screen. To
5
save the settings you've just made, don't forget to save your patch to
a user patch location.
11