Geneq SXBlue II Technical Reference Manual page 80

When issuing this command with the optional ',subset' data field (without the square
brackets), a one-line response is provided. The subset field may be either CONF or GP.
When CONF is specified for 'subset', the following response is provided:
This response is summarized in the following table:
Message
Component
$>JSHOW,CONF
N
0.0
10.0
5
A
60
W
When GP is specified for 'subset', the following is an example response provided:
This response will provide the >$JSHOW,GP message header, followed by each
message currently being output through the current port and also the update rate for that
message.
4.2.16 $JT
This command displays the revision of the receiver engine within the SXBlue II GPS:
The receiver will return the following response, indicating that the receiver is an SX2g
('g' for global differential operation) when in SBAS mode and SX2i when in Auto-Dif
mode ('i' for internal differential operation):
The list of responses is shown in the table below:
SXBlue II GPS Series Technical Reference Manual
$>JSHOW,CONF,N,0.0,10.0,5,A,60W
Message header
'N' indicates no altitude aiding
'0.0' indicates the aiding value, if specified (either specified
height or PDOP threshold)
Residual limit for the $JLIMIT command, which is not supported
by the SXBlue II GPS.
Elevation mask cut-off angle, in degrees
AIR mode indication
Maximum acceptable age of correction data in seconds
Current differential mode, 'W' indicates WAAS mode.
$>JSHOW,GP,GGA,1.0
$JT<CR><LF>
$>JT,SX2g
Active Application
WAAS (SBAS)
Auto-Dif
Local-Dif and Local-RTK
Local-Base
Description
$JT Reply
SX2g
SX2i
SX2r
SX2b
65