Fiat Idea Owner's Handbook Manual page 144

fig. 14
REFITTING THE STANDARD
WHEEL
Following the procedure described pre-
viously, raise the car and remove the spa-
ce saver spare wheel.
Versions with steel rims
Proceed as follows:
❒ Make sure the contact surfaces
between standard wheel and hub are
clean so that the fastening bolts will
not come loose.
❒ Fit the standard wheel by inserting the
first bolt for two threads into the ho-
le closest to the inflation valve;
❒ Fit the wheel cup making the groove
(on the cup) coincide with the inflation
valve and then insert the other three
bolts.
❒ using the wrench provided, tighten
the fastening bolts;
❒ lower the car and remove the jack;
❒ Using the wrench provided, fully ti-
ghten the bolts in the sequence
shown previously in the figure.
fig. 15
F0H0164m
fig. 16
IMPORTANT Incorrect assembly may
cause the cup to come off while travelling.
F0H0165m
F0H0166m
143