Table Of Contents; Introduction - Saunier Duval OPALIA X13 Installation And User Instructions Manual

INSTALLATION AND USER INSTRUCTIONS
WARNING, this appliance was designed, approved and inspected to meet the requirements of the English
market.
The identification plate located on the inside of the appliance certifies the origin where the product was
manufactured and the country for which it is intended.
If you see any exception to this rule, please contact your nearest Saunier Duval dealer.
Thank you in advance for your assistance.
INSTALLATION/MAINTENANCE SECTION
Introduction ................................................... Page 2
Dimensions ................................................................ 3
Heater schematic .................................................... 3
Technical data ......................................................... 4
Water heater Installation ........................................ 4
Flue configurations ............................................ 5 - 6
Installation ................................................................. 6
Electric power supply .............................................. 6
Commissioning & Lighting ....................................... 7
Safety devices .......................................................... 7
Servicing / Maintenance ........................................ 8
Draining ..................................................................... 8
Changing gas type ................................................. 8
Fault finding ...................................................... 9 - 10

INTRODUCTION

These instructions describe how to install and
use Saunier Duval appliances. It is important to
pay attention to the warnings on the packaging
and the casing of the appliances, and follow the
information given in this document.
These water-heaters are gas-fired appliances pro-
viding instant hot water to fill a sink or a bath.
The OPALIA X13 water-heater is of the room-sealed
type, that is the venting of combustion products and
the incoming fresh air pass through a flue system.
This venting principle offers a variety of advantages,
such as :
- installation with greatly reduced space require-
ments and with no need for room ventilation;
- a number of installation configurations depending
on the constraints of the premises.
2
OPALIA X13
Mandatory warning notice for CEE countries
USER SECTION
Introduction ................................................... Page 2
Commissioning & Lighting ....................................... 7
Safety devices .......................................................... 7
Servicing / Maintenance ........................................ 8
Draining ..................................................................... 8
The OPALIA X13 water-heater is of the II
category for use with either natural gas (G20),
butane (G30) or propane (G31)
The water-heater is delivered for a flue system
connection with a top outlet to right or left.
Its variable input means that whatever the rate at
which water is drawn, there will be instantaneous
hot water at a very nearly constant temperature
within the maximum capacity of the appliance.
The ignition system on this water-heater with no
permanent pilot has been designed to achieve
maximum energy saving.
UK
gas
2H3+