Philips AVENT Single electronic breast pump User Manual page 10

Single electronic breast pump
Hide thumbs Also See for Single electronic breast pump:
Table of Contents

Advertisement

Available languages

Available languages

Cracking or
• Avoid contact with antibacterial or abrasive
discolouration of
detergents/cleaners as they can damage the
pump/bottle parts
plastic. Combinations of detergents, cleaning
products, sterilising solution, softened water
and temperature fluctuations may, under certain
circumstances, cause the plastic to crack. If this
occurs, do not use. The pump body and breast
milk containers are dishwasher safe but food
colourings may discolour them. Follow guidelines
in 'How to clean and sterilise your pump'.
• Keep the product out of direct sunlight, as
prolonged exposure may cause discolouration.
Pump not
• Ensure the pump is correctly assembled and switched
on with the power indicator illuminated 'GREEN'.
responding
• Make sure the lead between the electrical wall socket
or battery pack and the pump is correctly connected.
Pump light
Pump light flashing RED
3 flashes etc.): If the pump works properly in Manual
flashing
RED
Control Mode but does not replicate in Automatic
Mode, the handle rhythm may have been too fast for
optimal milk expression. The machine is set not to
follow. Push the control button to return to Manual
Control Mode and use a slower handle rhythm.
• If this does not help and the power light still
flashes RED, the pump has detected a vacuum fault.
Disconnect the power and check the control
handle and diaphragm for obstruction or damage.
Pump light flashing RED
warning. Replace the batteries.
Difficulties separating
• The pump must be switched off via the control
button in order to separate these parts. If the
the control handle
batteries go flat mid-pumping, you may
from the pump body
experience difficulty. Replace the batteries or
connect the pump to the mains. Turn the pump
on by holding down the control button for 2
seconds – the light will turn GREEN. Now turn it
off by holding the button for 2 seconds – the light
will go off. You can now disconnect the pump
from the power supply and should be able to
separate the parts.
19
with delays (3 flashes, delay,
continuously: Low battery
20

Advertisement

Table of Contents
loading

Table of Contents