Hobie Gateway Assembly Manual page 7

Insert the crossbars into one hull. See
that the crossbars seat fully into their
sockets in the hull.
Using a cross bar as a lever arm, pull the hull to an upright
position so that the crossbars are horizontal.
Lifting one hull, or the
other, at the rear can
help align the socket
for the forward
spreader bar.
Slide the other hull onto
the crossbars until the
hulls come in contact
with the stop plates
(located on the
underside of the main
and aft crossbars).
Re-Install the screws
into each end form
the outside of the
hull. Do not over
tighten or compress
the plastic hull
material.
Unroll the trampolines from the forward crossbar. Slide the
main trampoline bolt ropes into the hull trampoline tracks.
Soapy water can be used as a lubricant (Do not use an oil or
silicon lubricant on the trampoline track or the bolt rope).
Sliding the bolt rope into the track is a 2 person job. One
person should pull the trampoline and the other feed the bolt
rope into the track.
5
Be sure the
f o r w a r d
spreader is fully
seated in both
hulls.