JVC GR-DVL725 Instructions Manual page 60

60
EN
Program
N I OUT MODE
1 – – – – : – – ~
2 ~
3 ~
4 ~
5 ~
6 ~
7 ~
8 ~
T I ME CODE – – : – –
TOTAL 0 0 : 00
Remote sensor
EFFECT EDIT IN/OUT
RM-V717U
(Provided with
GR-DVL820 only)
NOTES:
When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.
If the search time for an in-point exceeds 5 minutes, the recording deck's Record-Standby mode will be canceled and
editing will not take place.
If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited
version.
Since time codes register time only as accurately as seconds, the time code total time may not match the total program
time exactly.
Turning off the camcorder's power erases all registered Edit-In and Edit-Out points.
For GR-DVL820 Owners:
If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Black & White Fader.
In this case the Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off.
To combine these effects, use Sepia or Monotone during recording, then use the Black & White Fader during Random
Assemble Editing.
It is not possible to use Fade/Wipe effects and Program AE with special effects during Random Assemble Editing using
a DV cable.
Random Assemble
Editing Menu
FADE/WIPE
REW
FF
PLAY
R.A.EDIT
ON/OFF
IN/OUT
ON/OFF
CANCEL
RM-V700U
OR
(optional)
USING THE REMOTE CONTROL UNIT
4
Point the remote control at the camcorder's
remote sensor. Press PLAY (4) and then press
R.A.EDIT ON/OFF or ON/OFF on the remote control.
The Random Assemble Editing Menu appears.
5
For GR-DVL820 Owners:
If using a Fade/Wipe at the beginning of the scene,
press FADE/WIPE on the remote control.
• Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
6
At the beginning of the scene, press EDIT IN/
OUT or IN/OUT on the remote control. The Edit-In
position appears in the Random Assemble Editing
Menu.
7
At the end of the scene, press EDIT IN/OUT or
IN/OUT. The Edit-Out position appears in the Random
Assemble Editing Menu.
8
For GR-DVL820 Owners:
If using a Fade/Wipe at the end of the scene, press
FADE/WIPE.
• Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
• If you select a Fade/Wipe effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
• When you use Fade/Wipe effects, that time is
included in the total time.
9
For GR-DVL820 Owners:
If using Playback Special Effects, press EFFECT
( pg. 56).
10
Repeat steps 6 through 9 to register additional
scenes.
• To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
• For GR-DVL820 Owners:
If you are not using Fade/Wipe or Program AE with
special effects, repeat steps 6 and 7 only.
SELECT SCENES
(cont.)