Automatic Demonstration - JVC GR-DVL725 Instructions Manual

6
EN
Automatic Demonstration takes place when "DEMO
MODE" is set to "ON" (factory-preset).
Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch is set to "
" " and no cassette is in the camcorder.
Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
"DEMO MODE" remains "ON" even if the camcorder power is
turned off.
To cancel Automatic Demonstration:
1. Set the Power Switch to "
Lock Button located on the switch and press the MENU/
BRIGHT wheel in. The Menu Screen appears.
2. Rotate the MENU/BRIGHT wheel to select "
and press it. The SYSTEM Menu appears.
3. Rotate the MENU/BRIGHT wheel to select "DEMO MODE"
and press it. The Sub Menu appears.
4. Rotate the MENU/BRIGHT wheel to select "OFF" and press
it.
5. Rotate the MENU/BRIGHT wheel to select "
and press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on
the LCD monitor or viewfinder.
How To Attach The Lens Cap
To protect the lens, attach the provided lens cap to the camcorder as shown in the illustration.
NOTE:
To confirm the lens cap is on correctly make sure the cap is flush to the camera.
1

AUTOMATIC DEMONSTRATION

" while pressing down the
2
MENU/BRIGHT Wheel
" or
Lock Button
SYSTEM"
RETURN",
3
Power Switch
Sub Menu
DEMO MODE – OF F
ON
The lens cap can
be attached only
when the lens
hood is attached
to the camcorder.