Table of Contents
Advertisement
28
EN
Previous scene end
[Ex.:
Within 5 minutes . . .
Wipe-in
Recording Start/Stop Button
P
WIPE – SCROLL]
RECORDING
PICTURE WIPE OR DISSOLVE SELECTION
(
,
,
P
P
Combine the Picture Wipe and Dissolve functions for a
professional transition effect. There are 6 Picture Wipe
effects and 1 Dissolve effect. The Picture Wipe or Dissolve
works when recording is started.
Before the following steps, perform steps 1 through 3 on
pg. 27.
4
STORE SCENE IN MEMORY
Engage the Record-Standby mode.
If you select Picture Wipe/Dissolve during
recording . . .
.... press the Recording Start/Stop Button when one
scene is finished. The point at which the scene
ended is stored in memory.
If you select Picture Wipe/Dissolve during Record-
Standby mode . . .
.... press the Recording Start/Stop Button to start
recording and press it again when one scene is
finished. The point at which the scene ended is
stored in memory.
If you select Picture Wipe/Dissolve during Record-
Standby mode after performing a Picture Wipe/
Dissolve . . .
.... the point at which the scene ended is already
stored in memory.
5
START RECORDING
If you start recording a new scene within 5 minutes of
the end of the previous recording (without having
turned the camcorder's power off), the previous scene
wipes out, revealing the new scene.
NOTES:
You can extend the length of a Fade or Wipe by pressing
and holding the Recording Start/Stop Button.
If the power is turned off after a scene is finished
recording, the stored point is erased.
This disables the Picture Wipe/Dissolve combination.
When this happens, the Picture Wipe/Dissolve indicator
blinks. Try recording again, but do not turn the power off
when you are finished. Please be advised that power
also shuts off automatically if 5 minutes elapse in the
Record-Standby mode.
The sound at the end of the last recorded scene is not
stored.
Advanced Features (cont.)
,
,
,
P
P
P
P
and
)
P
Advertisement
Table of Contents
