Unpacking - usi 1800-2700 Owner's Manual

Photo 7-1
Photo 7-2
UNPACKING YOUR LAMINATOR
Your laminator comes packed in one carton. It
contains (1) laminator, (1) heat guard, (1) top
supply mandrel, (1) bottom supply mandrel,
(1) threading board, (1) feed table with guide,
(1) set of keys if equipped with a key lock, and
this operation and maintenance manual. (See
diagram page 5)
First, open the box. Using two people, carefully
lift the laminator from the carton by grasping
the side housings and lifting. Do not lift by the
upper idler bar or supply mandrel. These are
not weight bearing parts and can cause dam-
age to the machine.
For shipping purposes, white plastic tie straps
are used to hold the power cord, heat shoes,
and accessories in place. These straps are
approximately 1/8" wide and should be care-
fully cut and removed prior to set up.
Be sure to save the shipping carton...
Should your laminator ever need to be returned
for service, this carton ensures safe transit.
You new laminator comes pre-loaded and ready
to run. Install the feed table and heat guard as
shown on page 12. Plug the machine in and
turn the heat switch to the "on" position and
allow to heat for approximately 15 minutes.
After 15 minutes of heating time, set the Motor
Drive Switch to the "Forward" position and
allow the Rubber Rollers to rotate 1/2 turn. Set
the Motor Drive Switch to the "Off" position
and allow the machine to heat an additional 15
minutes before use. Check the heat setting and
adjust if necessary as shown on page 11.
7