Makita DUR182L Instruction Manual page 10

ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
carrying out any work on the trimmer. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Only for model DUR183L
1
2
1
013831
To mount the attachment to a power unit:
1. Make sure that the lever is not tightened.
2. To open the entrance of the joint, depress the
joint cover.
4
5
2
3
013832
3. Align the protrusion on the pipe (cutting tool side )
with the concave portion of the joint part.
4. Insert the attachment pipe into the joint part.
Make sure that the surface of the lock lever is
horizontal to the pipe.
5. Tighten the lever firmly as shown.
To remove the attachment, loosen the lever, press the
front part of the lock lever and then slide the pipe.
1. Joint
2. Lock lever
3. Joint cover
3
4. Lever
2
5. Pipe (Cutting
4
tool side)
5
1. Lock lever
2. Concave portion
1
3. Protrusion
3
Installing the grip
2
2
3
4
014155
Fit the grip onto the shaft pipe and tighten it with two
hex bolts. Make sure that the spacer on the shaft pipe is
located between the grip assembly and the other grip.
Do not remove or shrink the spacer.
CAUTION:
For model DUR183L, never install the grip on the
•
joint.
Installing the guard
WARNING:
Never use the trimmer without the guard in
•
place. Failure to do so can cause serious personal
injury.
013813
013839
Align the protrusions on the protector with the grooves
of the motor housing.
10
1. Grip
1
2. Hex bolts
3. Cover
4. Clamps
5
5. Cutting tool side
6. Spacer
6
1. Grooves
2. Protector
1
2