Programming Remote Control; Direct Device Code Setup - JVC 32" User Manual

7. Programming Remote Control

A. Direct Device Code Setup
Although your Remote Control is set up to provide control of this TV, you can specify other
devices to be controlled, according to the following steps.
[MODE] → <<SET>> (2 blinks) → 5- digit device codes (2 blinks)
STEP 1 Locate the desired device in the Device code list.
STEP 2 Select the [MODE] by pressing VCR, CBL, or AUX.
[MODE]
TV
VCR
CBL
AUX
STEP 3 Depress and hold <<SET>> button for a minimum of 3 seconds until LED blinks twice.
STEP 4 Enter the 5-digit code for the desired device. The LED blinks once for every digit
entered except for the last digit, where it shall blink twice to confirm that a valid code
has been programmed.
NOTE
* Each digit must be entered within 10 seconds, or the Remote Control shall exit
programming state.
* Two short LED blinks indicate recognition of the code, after which device control via
the remote is enabled.
* A long LED display indicates non-recognition of the code, at which time the code
should be re-entered.
Example: [VCR]
→
26
Device Assignment
Locked to this TV (Default)
Universal VCR, DVD, PVR
Universal Cable, Satellite, Video Accessory
Universal Tuner, Amplifier, CD, Mini Disc.
And Misc. Audio, Home Automation
<<SET>> (2 blinks)
→[2]→[0]→[0]→[3]→[5]
Device
Group no.
-------
2
0
3
(2 blinks).