Install The Extender As An Access Point - NETGEAR WN3000RPv3 Installation Manual

2. Connect the extender to an existing WiFi network.
3. Plug the Ethernet cable from an Ethernet-enabled device in to the
Ethernet port on the extender.

Install the Extender as an Access Point

You can use the extender as a WiFi access point, which creates a new WiFi
hotspot by using a wired Ethernet connection.
1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet.
The Power LED
does not light, press the Power button.
3. Use a WiFi network manager on a computer or WiFi device to find and
connect to the NETGEAR_EXT (SSID) WiFi network.
After the connection with the computer or WiFi device is established,
the Client Link LED
4. Open a web browser window from the same computer or WiFi device.
The browser takes you directly to the NETGEAR genie Smart Setup.
If you are not automatically directed to NETGEAR genie, launch a web
browser and type www.mywifiext.net in the address field.
lights green within one minute. If the Power LED
lights.
14