Page 1
Other Wi-Fi ADT Pulse peripheral devices include indoor and outdoor IP Cameras and touchscreens. Place your Wi-Fi Extender between the ADT Pulse Gateway and the device(s) that are out of range or having trouble communicating with the Gateway. After adding the Wi-Fi Extender, test the device(s) to ensure all devices are now communicating properly.
Page 2
ADT Pulse Wi-Fi Range Extender Open a web browser and in the address bar, enter: https://portal.adtpulse.com. Type your Username and Password, and then click Sign-In . Wi-Fi Range Extender WN3000RPH-2ADPAS How to Remove a Wi-Fi Extender: On the System tab, select the Wi-Fi Range Extender to be deleted.
Page 3
How to Enroll a Wi-Fi Extender: Select the System tab, and then click Manage Devices . On the Manage Devices screen, click Wi-Fi Extenders . Note: There can only be one Wi-Fi Extender per ADT Pulse system. https://alpha.adt.com/help/108[11/12/2018 10:11:06 PM]...
Page 4
At the bottom left of the screen click Add Note: When the Add button is grayed out and it states, “No more can be added”, the original Wi-Fi Extender must be removed first. On the Add Wi-Fi Extender screen, select the NETGEAR WN3000RPH-2ADPAS model. Locate the MAC ID on the rear of the Wi-Fi Extender you are adding.
Page 5
7. Use a standard Ethernet cable to temporarily connect the new Wi-Fi Extender to the device LAN port of the ADT Pulse Gateway or Total Security (TS) Base unit. You will be able to relocate the device when the enrollment is complete.
Page 6
ADT Pulse Wi-Fi Range Extender Wait while the Wi-Fi Extender is added to the system. This could take a few minutes. In the Name field, assign a unique name to the Wi-Fi Extender and then, click Save in the upper right portion of the screen.
Remove the Ethernet cable, and then unplug the Wi-Fi Extender from the electrical outlet. Locate the Wi-Fi Extender to its permanent position and plug it into an electrical outlet. Within a few minutes of plugging it back in, the ADT Pulse system recognizes the extender and places it back online. Factory Reset...
To reset this device, press the Reset button on the ADT Pulse Nano for one second, and then release. The Reset button is recessed in a small opening and requires the use of a paper clip to reach it.
Page 9
ADT Pulse Wi-Fi Range Extender showing an "offline" status. Pulse Nano EOP Adaptor Information about getting started with the ADT Pulse Nano EOP Adapter. Pulse Range Extender Information about getting started with the ADT Pulse Wi-Fi Range Extender. Return to Top...