Install The Extender As An Access Point - NETGEAR EX7000 User Manual

through the extender's WiFi connection.
Ethernet LAN ports (5)
Figure 7. Rear panel Ethernet LAN ports

Install the Extender as an Access Point

You can cable your extender to your existing router and then set up the extender in access
point mode to work to create a new WiFi hotspot.
To use the extender in access point mode:

1. Attach the stand or the rubber feet.
For more information, see
page 10.
2. Attach the antennas.
For more information, see
3. Use an Ethernet cable to connect your router to the Ethernet port on the extender.
Ethernet
WiFi router
4. Turn on your extender.
Plug the extender into an electrical outlet. Press the Power button if necessary.
The NETGEAR LED lights white and the Link Rate LEDs and the Device to Extender LED
light amber and then turn off.
AC1900 Nighthawk WiF Mesh Extender
Attach the Stand on page 9 or
Attach the Antennas
Get Started
18
Attach the Rubber Feet
on page 10.
Extender Ethernet LAN port
on