Place The Extender And Apply Power; Connect To An Existing Wifi Network; Install The Wifi Extender - NETGEAR WN3000RPv3 Installation Manual

Install the WiFi Extender

Place the extender, apply power, and connect it to your WiFi network.

Place the Extender and Apply Power

1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet.
The Power LED
does not light, press the Power button.

Connect to an Existing WiFi Network

To extend the range of your WiFi network, you must connect the extender
to your existing WiFi network. You can do this in one of two ways:
• Connect with WPS. For more information, see
.
page 7
• Connect with web browser setup. For more information, see
Connect with Web Browser Setup
lights green within one minute. If the Power LED
on page 8
6
Connect with WPS
.
on