Diamondback SHEPPARD CYCLES Owner's Manual page 69

Screw in the removal tool. Turn the screwbolt clockwise.
Position the crank on the axle. Lightly tap the crank onto the axle.
Tighten the flange nut. Replace the dust cap.
Cotterless Crank Replacement:
1 . Replace the crank arm onto the axle.
2 . Tap the crank arm lightly with a mallet.
3 . Refit the washer and tighten flange nut or bolt securely to a torque
of 27Nm.
4 . Replace the dust cover.
New cotterless cranks may become loose with initial use.
Perform the following task after several hours riding,
and repeat it two or three times after further use.
Cranks should then remain tight.
1 . Remove dust cap.
2 . Tap the crank arm lightly with a mallet.
3 . Re-tighten the flange nuts, and refit the dust caps.
SC/2012
SHEPPARD CYCLES ABN 60 082 376 289
67